Technical data

68
Construct th ircuit on a readboard. Connect the testing jig according to the test
points (TP’s) in the schematic dia Make sur u may refer to the
table on the previous page.
When finish , have your lab part instructor
While troubleshooting the circuit, you may not view the breadboard connections. You may use either a
voltmeter or ammeter (no ohmmeters) to take measurements from the terminal block on the testing jig.
Record each step in the troublesh process o s and Conclusions Table” for this
exercise.
Observations Conclusions
Troubleshooting Exercise 1
e following c solderless b
gram. e the correct TP wires are used. Yo
ed ner or create a fault in the circuit.
ooting n the “Observation
DC
TP1
TP2
TP4
TP3
TP5
P6
TP7
+15 V

R
1
1 k
R
3
3.3 k
T
R
2
4.7 k