Instruction manual

C9 - .047μF Discap (473)
R5 - 8.2kΩ 5% 1/4W Res.
(gray-red-red-gold)
R6 - 10Ω 5% 1/4W Res.
(brown-black-black-gold)
Socket IC 8-pin
IC2 - LM-386 IC
(see Figure D)
C6 - 470μF Electrolytic
(see Figure Ca)
C7 - 470μF Electrolytic
(see Figure C)
R3 - Potentiometer
Nut & Washer
Knob
Solder 5 lugs
to PC board.
-6-
ASSEMBLE COMPONENTS TO THE PC BOARD
Tuning Capacitor
Figure F
Your kit may contain a 3 lead or a 4 lead capacitor. Bend the leads as
shown. Fasten C1 into place on the top side of the PC board with two M2.5
x 3.8mm screws. Fasten the knob to the shaft of the gang with an M2.5 x
7.5mm screw.
Solder leads
to pads
3 Leads
4 Leads
Foil Side
Figure G
Turn the dial fully clockwise.
Remove the protective backing
from the label and align the 1600
with the arrow on the PC board.
NOTE: SAVE the protective
backing from the label for it will be
used on page 8.
M2.5 x 3.8mm
Screws
Knob
Tuning Capacitor
2 M2.5 x 3.8mm Screws
1 M2.5 x 7.5mm Screw
1 Knob (Dial)
1 Label
(see Figures F and G)
Speaker 8Ω
Speaker Pad
2 Wires
(see Figure E)
Foil Side
Tuning Capacitor
Screw Holes
Knob Post
NutWasher
PC Board
M2.5 x 7.5mm
Screw