0 YEAR MANUFACTURER'S LIMITED WARRANTY All parts of this Elements of Design faucet are warranted fo the original retail purchaser to be free from defects in material and workmanship for a period of Ten(10) years from the date of purchase as shown on the purchaser's receipt This warranty is limited to defective parts only, labor charges landlord damage resulting from improper installation, repair or replacements, as well as incidental and consequential damages connected therewith are excluded.
INSTALLATION INSTRUCTIONS For Use With OD's Twin Handles Lavatory Faucet with Pop-Up BEFORE BEGINNING INSTALLATION 1. Fl lush plumbing lines to clear any debris. 2. Shut off both supply lines after flushing. [1] 7] 1. Shut off hot and cold water supply under sink. Plug sink drain with cloth to avoid losing small parts. Remove old faucet. 2. Insert the inlet shanks through the sink holes, and press down. Assemble the washers and lockouts on the inlet shanks, and then tighten the nuts by hand.
Parts: Replacement Parts: Hot Carl ridge KSRPL2D0DHC Cold Cartridge: KSRPL2000CC Handle: KBH1601AL CARE AND MAINTENANCE OF YOUR FAUCET Your Elements of Design faucet has been finished lo he mast strict standards; however, due to the high content of minerals in the water, your finish may appear dull and famished after time. These are some do's and don'ts to maintain the luster on your faucet for many years to come. Do 1. Use a silicon based caulking when installing. 2.
