Instruction Manual

Record care and maintenance
To ensure the best sound and the least amount of wear on your records, it’s essential that they are
kept clean. Make sure your records, especially older ones are sufficiently cleaned prior to playing
them thoroughly clean dust off the stylus and record regularly. Use a soft brush to clean the stylus.
Brush from the base to the tip as shown below.
For records with only light amounts of dust, we recommend brushing them off with a carbon fibre
brush or velvet pad before playing them. Use a good quality record cleaner and brush set to keep
your records clean. Carbon fibre brushes, velvet pads and record cleaning kits are available online or
in local record stores.
USB/SD Playback
1. Turn the volume knob in a clockwise direction to switch on the turntable.
2. Insert the USB/SD card into the correct slot.
3. Use the function selector to select USB/SD mode.
4. Wait for 6-10 seconds. Once the unit reads the total tracks, it will auto-play them.
5. Press “Mode” button to convert the USB/SD Tracks. (default for U-disc play)
6. Press “Play/PAUSE” to Pause, press again to play.
7. Press “PREV” to play previous track.
8. Press “NEXT” to play next track.
9. Keep pressing “PREV” for 3 seconds to decrease the playback volume of source-disc.
10. Keep pressing “NEXT” to increase the volume.
USB / SD card Encoding
1. Simply insert the USB stick / SD card into the USB jack / SD card slot.
2. Press “REC” button to start recording the record while the record is playing.
Notes:
• A USB device must always be connected directly to the USB port of this product. The use of a
USB extension cord is not supported by this product. The USB port of this product cannot
communicate with a computer directly.