Instructions / Assembly

ManualsBrandsElementi ManualsFire PitsFiery Rock 50 in. Round Eco-Stone Natural Gas Fire Pit in Natural Brown

12/18

WARNING

When using t his method t o l ight your

fire table use heat resistant gloves

and follow the step by step

instructions. Failure to do so could

result in severe injury.

WARNING

DO NOT wear loose or flammab le

clothing while lighting fire tab le.

WARNING

If burner flame goes out during operation, immediately

turn t he control knob “OFF” and let the gas clear a

minimum of 5 minutes before atte mpting to re-light the

fire table.

LIGHTING INST RUCTIONS

Using the Igniter

1. Read and understand all op er atin

instructions before li

htin

. Ensure th at all protective

film has been removed from stainless burn tray prior to lighting.

2. Burner control knob must be in the “OFF” position.

3. Connect natural ga s source (se e above pages).

4. Open the natural gas su pply to the unit.

5. Push and hold igniter but t u rn to create sparks.

6. While holding the igniter button with one h and, use your other hand t o push and turn t he control knob

to the “LIGHT” position to light the burner.

7. Keep the burner control knob pressed in for 15-30 seconds after ignition.

8. If i gnition does not occur in 30 seconds, turn control knob to the “OFF” position and turn gas off at the

source, wait 5 minutes until gas has cleared and repe at lightingprocedure.

After lighting, rotate the burner control knob counter clockwise to “Low” setting.

Observe flame, make sure all bu rner ports are lit. Flame height should be no higher than

13 inches t all.

10. Adjust the f lame to the desired height with the control

knob.

Using a Long Match or Lighter

1. Prior to lighting, use a sho vel to move

the lava ro cks for access to the burner.

2. Wearing heat resistant gloves, position the bu rning long

match or burn ing butane lighter near the side of the

burner. Do NOT lean over the fir e table while lighting!

3. Turn control knob coun ter clockwise t o “LIG HT”.

4. Remove long match/long butane lighter.

5. After lighting, use a shovel and heat resistant

gloves to ca refully move the lava rocks back

into their proper position.

6. After lighting, rotate th e burner control knob co unter

clockwise to “Low” setting. Observe the flame, make sure

all burner ports are lit. Flame height should be no higher

than 13 inches tall.

7. Adjust the flame to the desir ed h eight with the

contro l knob.

Please refer to the trouble sho oting pages

for additional support, beginning on page 17.

Control Knob