Full Product Manual

13 / 19
LIGHTING INSTRU CTIONS
Using the Ignitor
1. Read and understand all operating instructions before lighting Ensure that all protective film
has been removed from stainless burn tray prior to lighting.
2. Burner co ntrol knob must be in the “OFF” position.
3. Connect propane (LP) cylinder (see previous pages).
4. Slowly open valve on LP gas cylinder.
5. Push t o create sparks.
6. Push and turn th e cont rol knob to the “LIGHT” position
to light the burner.
7. Keep burner control knob pressed in for 15-30 seconds after gnition.
8. If ignition does not occur in 30 seconds, turn control knob to the “OFF ” position and t urn gas
off at the source, wait5 minutes until gas has cleared and repeat lighting procedure.
9. After lighting, rotate the burner control knob counter cl ockwise to “Low” setting. Observe
flame, make sure all burner ports are lit. Flame heigh t should be no higher than 13 inches tall.
10. Adjust the flame to the desired height with the control knob.
Using a Long Match o r Lighter
1. Prior to lighting, use a shovel to move lava rocks for
access to the burner.
2. Wearing heat resistant g loves, position the burning
long match or burning butane lighter near the side o f
the bur ner. DO NOT lean over the fire table while
lighting!
3. Turn control knob counterclockwise to “LIGHT”.
4. Remove long match/lon g butane lighter.
5. After lighting, use a shovel and heat resistant gloves
to careful ly move the lava rocks back into their proper
position and replace the glass pa nel.
6. After lighting, rotate the burner control knob counter
clockwise to “Low” settin g. Observe flame, make sure
all burner ports are lit. Flame height shou ld be n o
higher than 13 inches tall.
7. Adjust t he flame to the desired height with the control
knob.
！
WARNING
When using this method to light yo ur
fire table use heat resistant gloves and
follow t he step by step instructions.
Failure to do so could result in severe
injury.
Control Knob
! WARNING
If burner fame goes o ut during operation, immediately urn
the control knob “OFF” and let the gas clear a minimum of
5 minutes before attempting to re-light the fire table.
Please refer t o the trouble shooting pages for
additional support, beginning on page 18.