Instructions / Assembly

ManualsBrandsElementi ManualsFire PitsBlazing Timber 37 in. Round Eco-Stone Natural Gas Fire Pit in Natural Brown

12/18

WARNING

When using this method to light your

fire table use heat resistant gloves

and follow t he step by step

instructions. Failure to do so could

result in severe injury.

WARNING

DO NOT wear loose or flammable

clothing while lighting fire ta ble.

WARNING

If burner fla me goes out during operation, immediately

turn t he control knob “OFF” and let the gas clear a

minimum of 5 minutes before attempting to re-light the

fire table.

LIGHTING INST RUCTIONS

Using the Igniter

1. Read and u nderstand all operatin

instructions before li

htin

. Ensure that all protective

film has been removed from stainless burn tray prior to lighting.

2. Burner control knob must be in the “OFF” position.

3. Connect natural gas source (see above pages).

4. Open the natural gas su pply to the unit.

5. Push and hold igniter but t urn to create sparks.

6. While holdin g the igniter button with one hand, use yo ur other hand to push and turn the control knob

to the “LIGHT” position to light the burner.

7. Kee p the burner control knob pressed in for 15-30 seconds after ignition.

8. If ignition does no t occur in 30 seconds, turn control knob to the “OFF” position and tu rn gas off at the

source, wait 5 minutes until gas has cleared and repeat lightingprocedure.

After lighting, rotate the burner control knob counter clockwise to “L ow” setting.

Observe flame, make su re all burner ports are lit. Flame height should be no higher than

13 inches tall.

10. Adjust the f lame to the desire d height with the co ntrol

knob.

Using a Long Match or Lighter

1. Prior to lighting, use a shovel to move

the lava ro cks for access t o the burner.

2. Wearing heat resistant gloves, positio n the b urning long

match or burn ing buta ne lighter near the side of the

burner. Do NOT lean over the fire table while lighting!

3. Turn control kn ob counter clockwise to “LIGHT”.

4. Remove long match/long b utane lighter.

5. After lighting , use a shovel and he at resistant

gloves to carefully move the lava rocks back

into their proper position.

6. After lighting, r otate the burner control knob counter

clockwise to “Low” setting. Observe the flame, make sur e

all burner po rts are lit. Flame he ight should be no higher

than 13 inches tall.

7. Adjust the flame to the desired height with t he

contro l knob.

Please refer to the trouble shooting pages

for additional support, beginning on page 17.

Control Knob