Installation Manual Gas Fires Summum 70
15
INSTALLATION MANUAL
12 LED MODULE
The Summum fireplaces of Element4 are equipped with lighting
under the burner grate. All fireplaces work with the same 10
button remote control (Figure 12.1). The explanation for this is
in the manual available for this. All the information in this section
is an addition to this, especially intended for using Element4
fireplaces with lighting.
12.1 Burner Bed
12.1.1 Glass bed arrangement
Each Summum fireplace has a three-part grid, which consists of
two trays and a middle section. The trays can be easily removed
for maintenance. The trays must be filled with the supplied glass
crystals.
Divide the glass evenly over the bottom so that the light is well
broken. Cover the glass with the chips, so that all the glass is well
covered, but light is allowed through.
With the Summum you have the possibility of an imitation
glowbed. The intensity of the glow can be changed as desired.
Note: When you completely switch o the fire and switch it on
again at a later time, the intensity at which you switched o the
fire will be the same when you switch the fire on again.
When you start the fireplace, the light bed will be switched
o at all times. Aer the start-up process, when the second
thermocouple has released the gas supply, the light bed will
automatically start to glow again.
12.1.2 Operation lighting
Brightness
The LED module can also be used to change the brightness of
the LEDs. To change this observe the following steps:
• Hold the lightbulb button (A on the remote) until the icon in
the screen starts to blink
• Press the up or down arrow (B and C) to change brightness
The final option is to have your LEDs pulsing, imitating the
glowing embers in a real fire.
Note: The 12V adapter that comes with the LED Module is to
be plugged into the LED module itself! This is contrary to other
Element4 fireplaces that feature a 6V plug which is put into the
receiver!
AM
PM
ON
1 2
OFF
(A)
(C)
(B)
Figure 12.1 - 10-Button Remote