Installation Manual Gas Fires Summum 140

INSTALLATION MANUAL
20
10.1.3 (Dis)assembly of the trims for the Summum 140 RD &
T (see image 10.8)
For a tight finish of the fireplace, trims are available. During
maintenance these trims must be removed, before the glass can
be removed. Please follow these steps:
Disassemble
• Remove both the side trims and bottom trim. They are held
by magnet snappers, Figure 10.9 & 10.10.
Assembly:
• Put the trims back in reversed order.
10.1.4 Remove glass
To be able to cleam the glass on the inside, one needs to remove
the glass. To do this follow these steps:
• Check, whether the trims are removed in as in step 10.1.3.
• Remove the glass clamps. (See Figure 10.11)
• Put the section cup on the glass and make sure it is properly
vaccuumed, so it will not come o . (See Figure 10.12)
• Li the glass out of the lower glass rail and tilt it out through
the opening, as seen in Figure 10.13.
NB: Put away the glass in a safe place, when you are not using
it, to make sure it will not damage during maintenance. Remove
the suction cup a er putting away the glass to avoid tracing or
stains.
NB: Under no circumstance may the head glass of a Lucius
140 be removed from the fireplace, for this will cause the fire
to collapse. Only remove this glass panel when transportation
brackets are still in place / are repositioned.
Figure 10.8 - Lucius- & Tenore 140