Installation Manual Gas Fires Summum 140

18
INSTALLATION MANUAL
10 MAINTENANCE INSTRUCTION
This part of the manual focuses on maintenance. To ensure the
optimal flame picture of your device, an annual maintenance by
a competent company or installer is prescribed.
10.1 Maintenance in the combustion chamber
Depending on the configuration of the Summum 140, for
example a front or corner model, the glass must be removed in
a specific way.
In this chapter the models are broken down into three groups;
• On this page and the page opposite you will find the
maintenance steps for the Summum 140 F, C & 3S.
• For the Summum 140 RD and T you are referred to sections
10.1.3 and 10.1.4
• For the Summum 140 4S to sections 10.1.5 and 10.1.6 on
the following pages.
10.1.1 (Dis)assembly of the trims
For a tight finish of the fireplace, trims are available. During
maintenance these trims must be removed, before the glass can
be removed. Please follow these steps:
Disassemble
• Remove both the side trims and bottom trim. They are held
by magnet snappers, Figure 10.2 & 10.3.
Assembly:
• Put the trims back in reversed order.
10.1.2 Remove glass
To be able to cleam the glass on the inside, one needs to remove
the glass. To do this follow these steps:
• Check, whether the trims are removed in as in step 10.1.1.
• Remove the glass cords. (See Figure 10.4)
• Put the section cup on the glass and make sure it is properly
vaccuumed, so it will not come o . (See Figure 10.5)
• Li the glass out of the lower glass rail and tilt it out through
the opening, as seen in Figure 10.6.
NB: Put away the glass in a safe place, when you are not using
it, to make sure it will not damage during maintenance. Remove
the suction cup a er putting away the glass to avoid tracing or
stains.
Figure 10.1 - Trisore-, Bidore- & Modore 140