Installation Manual Gas Fires Summum 140
16
INSTALLATION MANUAL
9.4 Element4 ProControl App.
It is possible to operate your device via smartphone or tablet
with the ProControl App, available in the appstore on iOS and
google play on Android.
The app has a user friendly, interactive layout and the design is
adjusted for Element4 devices. Up to eight devices can be used
with one app, in the situation that multiple fire are installed in
the same location.
Another functionality of the app is to pre-set the temperature
of you device, for a period of one week, to ensure yourself of an
optimal desired room temperature. Also the device can changed
between high and low flames and it features an eco-setting.
The amount of users, that can operate the device is unlimited,
so every family member can make use of it, by easily making a
personal account. By two-way communication, one can check
on the device at any moment.
For the Summum 140 it also applies that the burners can be
operated with the app and that the light intensity can also be
controlled from the telephone / tablet.
Necessities for the installation of the ProControl:
• 220 volt electricty near the fire
• Wi-Fi code of the router
• Smart Phone or tablet
• ProControl manual
Should any problems occur you can always check APPENDIX B.
9 ELECTRICAL CIRCUIT
Figure 9.1 shows a simplified connection circuit for the fireplace.
Every fireplace is provided with a main adapter.
9.1 Parts in the electrical circuit
# Omschrijving
(1) Gas Block
(2) Receiver
(3) Flat Burner
(4) First and second (long) logburner
(5) Third and fourth (short) logburner
(6) Pilot set
(7) Second Thermocouple
(8) Quad Module
(9) LED Module
(10) LED strips
(11) Wifi Box
9.2 Domotica
The receiver oers the possibility to be connected to a domotica
system. A special connector is being supplied for this. Type: G60-
ZCE
9.3 Modules
The Summum 140 is provided with two additional modules,
outside the regular electronics, the LED module and the Quad
Module, respectively. You will find more information about the
operation of both modules in
CHAPTER 12.
Both modules work with their own power supply, respectively
a 6V adapter and a 12V adapter; Thus, there must be two 220V
power points present for the stove to work properly. The ports
are indicated in the overview with the architectural sign and the
corresponding current.
Very important:
The LED module of the fireplace works with a 12V adapter and
should only be used on this module! Use of the 12V adapter
on the receiver or Quad Module, ensures that this irreparable
damage is incurred and can no longer be used.
Element4 cannot be held liable for incorrect use of the adapters!
See figure. 9.1 for correct connection.