User manual Element4

SELECTED
1 2
ON
AM
PM
OFF
1 2
ON
AM
PM
OFF
NOTE: Either continue to PROGRAM 2 and set on and off times
or stop programming at this point, and PROGRAM 2 re-
mains deactivated.
NOTE: PROGRAM 1 and 2 use the same on (Thermostatic) and
off temperatures for
, and Daily Timer ( , , , , ,
, ). Once a new on (Thermostatic) and / or off tempera-
ture has been set, that temperature becomes the new
default setting.
NOTE: If
, or Daily Timer are programmed for PRO-
GRAM 1 and PROGRAM 2 on and off times, these be-
come the new default times. The batteries must be re-
moved to clear the PROGRAM 1 and PROGRAM 2 on
and off times and temperatures.
AUXILIARY FEATURE (2ND BURNER FEATURE)
The latching solenoid valve will open automatically after ignition
or after switching the system off, so that the maximum flow of
gas is supplied to both burners assisting with the ignition pro-
cess. After pressing the AUX-button the motor will turn 7 sec-
onds in the ON direction until the max. position is reached.
1 2
ON
AM
PM
OFF
ON:
To switch a burner on, press the but-
ton.
displayed.
OFF:
To switch the burner off, press the
button. disappears.
NOTE: The latching solenoid valve cannot operate manually. If
the Receiver battery runs down it will remain in the last
operating position.
ECO MODE
AM
ON:
Press
button to enter Eco Mode.
displayed.
OFF:
Press
button. disappears.
CIRCULATING FAN OPERATION
AM
Circulating fan has 4 speed levels from
low (1 bar) to high (4 bars).
OFF:
Press
button until all 4 speed level
bars disappear.
NOTE: SETTING only. If the fan was not switched off after last
use, it starts automatically 4 minutes after ignition at max-
imum speed and goes to the last set level after 10
sec-onds. The fan stops
10 minutes after the gas is
OFF or at Pilot.
or Daily Timer ( , , , , , , ) selected
▪ Set on time and off time using same procedure as “
Selected” (above).
▪ : Set on time and off time for both Saturday and Sunday.
▪ Daily Timer: Unique on and off times may be set for a single
day of the week, for multiple days of the week, or for every day
of the week.
▪ Wait to finish setting.
ON TIME SETTING (PROGRAM 1):
7. , , displayed,
is displayed
8.
9.
shortly, and hour ashes.
To select hour press or button.
To conrm press button. , ,
displayed, displayed shortly,
and minutes ash.
or but-
10. To select minutes press
ton.
11. To conrm press button.
OFF TIME SETTING (PROGRAM 1):
12. , , displayed, is displayed
13.
14.
shortly, and hour ashes.
To select hour, press or button.
To conrm press button. , ,
displayed, displayed short-
ly, and minutes ash.
or but-
15. To select minutes press
ton.
16. To conrm press button.
SETTING:
1.
button and hold until
2.
Press
ashes.
Press
and
button to increase fan speed
button to decrease fan speed.
3. To conrm setting either press but-
ton or wait ( displayed).
USER MANUAL
9/16