Installation Manual Gas Fires Modore 185
8
INSTALLATION MANUAL
4 REMOTE CONTROL WITH FULL ELECTRONIC IGNITION
The unit is operated using a remote control (Fig. 4.1) or the
Element4 Puck, connected to a receiver (Fig. 4.2).
The receiver is powered by 4 pen lite (type AA) batteries or a 6V
adapter; 2 penlight batteries (type AAA) are used for the remote
control. The life of the batteries is about a year with normal use.
4.1 Adjusting the communication code
Before using the appliance, a communication code must be set
between the remote control and the receiver. The code is chosen
at random from the 65000 available codes. Therefore there is a
slim chance that other remotes in your area use the same code.
Please do the following
Press the reset button on the receiver until you hear two beeps.
Aer the second longer signal, let go of the reset button (Fig.
4.2).
Within 20 seconds, press the down arrow on the remote control
until you hear a sound signal. This is confirmation of the proper
communication.
4.2 Igniting the pilot light
Check that the control knob (A) is in the ON position( Fig 4.3).
Press the button on/o button of your remote control and
continue to hold down (3 to 5 sec.) until you hear two short
beepes.
The ignition sign will appear at the top of the screen (Fig. 4.1)
Now release the button. The ignitionprocedure is started.
NB: If the pilot light doesn’t remain lit aer 3 attempts you must
turn o the gas tap and warn your installer.
4.3 Igniting the main burner
Aer starting the pilot, knob B will automatically rotate counter
clockwise and the main burner will start burning (Fig 4.3).
Always wait 5 minutes aer killing the pilot light before you start
the pilot flame again.
NB: The pilot light must ignite the main burner, evenly and
without a thud, if it does thud, close the gas tap and warn your
installer.
4.4 Switching o the fireplace
You switch o the fireplace by pressing the on/o button, this
also turns o the pilot light! For a detailed description of the
E-save remote control, please refer to the E-save manual which
is included with the fireplace.
Figure 4.2 - Receiver
AM
PM
ON
1 2
OFF
Figure 4.1 - Remote and ignition sign
Figure 4.3 - Gas Block