Installation Manual Gas Fires Modore 185
APPENDICES
22
Error
code
Message in App Description Possible cause
F02 Contact service 5 sec beep van de ontvanger.
Geen reactie van ontvanger, en geen ontsteking.
• No engine end stop
• Wiring motor
• Microswitch
• Knob B
F03 Contact service 5 seconds beep from the receiver.
Ignition process is interrupted
No response from receiver, and no ignition.
Thermocouple wiring not in order / interrupted
F04 Ignition failure. wait 1
minute, than try again.
No pilot flame within 30 sec.
After 3rd attempts F06
• No gas
• Air in the pipe
• No spark
F06 Contact service 3rd time start attempt within 5 minutes • No gas
• Air in the pipe
• No spark
F10 Contact service Pilot is on
2nd thermocouple procedure
Starting again after 2 min
• 2nd thermocouple is not heated
• 2nd thermocouple blocked by decoration material
F12 Contact service Motor turns to pilot light position • Receiver above 60 °
F13 Contact service Motor turns to pilot light position • Receiver above 80 °
F14 Contact service 5 sec. beep
No reaction from the fireplace and no ignition
• Wiring not in order
• 2nd thermocouple interrupted
• No right recipient
F15 Contact service 5 sec. beep
No reaction from the fireplace and no ignition
• 2nd thermocouple not connected
• Wiring 2nd thermocouple
F16 Hand transmitter out of
reach
No temperature in the app • Hand transmitter out of reach for more than 1.5 hours.
• Electrical fault
F17 Contact service No ignition
No reaction from the fireplace
• Voltage above 7.5 volts
• AC adapter defective
F19 Contact service Pilot flame goes out when the main burner is
opened
• 1st Thermocouple voltage not sufficient
• 1st thermocouple defective
• Too low pressure
• Resistance in the thermocouple circuit
• Gas control block (magnetic coil)
F26 Contact service No high flame regulation possible • Receiver above 60 °
F28 On-Demand pilot Pilot flame goes out • Pilot flame goes out after there has been no motor
movement for a long time.
F31 Contact service No reaction from the fireplace
No control possible by the electronics
• Receiver defective
F41 Controleer Wi-Fi No reaction from the fireplace • No Wi-Fi connection
F43 No receiver connected.
Contact service
No reaction from the fireplace
No control possible by the electronics
• No communication between receiver and Wi-Fi
module
F44 Contact service No temperature display in the App
“N.a.” in the App
• No hand transmitter connected
• Batteries hand transmitter empty
B ERRORS CODES PROCONTROL APP