Installation Manual Gas Fires Modore 185
14
INSTALLATION MANUAL
10 MAINTENANCE INSTRUCTION
This part of the manual focuses on maintenance. To ensure the
optimal flame picture of your device, an annual maintenance by
a competent company or installer is prescribed.
10.1 Maintenance in the combustion chamber
During maintenance the glass windows of the fire need to be
removed. To do this follow the following steps:
10.1.1 (Dis)assembly of the trims
For a tight finish of the fireplace, trims are available. During
maintenance these trims must be removed, before the glass can
be removed. Please follow these steps:
Disassemble
• Remove both the side trims and bottom trim. They are held
by magnet snappers, Figure 10.2 & 10.3.
Assembly:
• Put the trims back in reversed order.
10.1.2 Remove glass
To be able to cleam the glass on the inside, one needs to remove
the glass. To do this follow these steps:
• Check, whether the trims are removed in as in step 10.1.1.
• Remove the glass cords. (See Figure 10.4)
• Put the section cup on the glass and make sure it is properly
vaccuumed, so it will not come o. (See Figure 10.5)
• Li the glass out of the lower glass rail and tilt it out through
the opening, as seen in Figure 10.6.
NB: Put away the glass in a safe place, when you are not using
it, to make sure it will not damage during maintenance. Remove
the suction cup aer putting away the glass to avoid tracing or
stains.
10.2 Cleaning the glass
Keep in mind the following when cleaning glass:
• Always clean the glass at room temperature.
• Use cleaning supplies qualified by Element4.
• When you clean your Anti-Reflective glass, make sure
you use this with the special Element4 cleaner, which is
available only via Element4.
• Use only a microfibre cloth. Other materials such as kitchen
towels, steel wool etcetera can cause scratches or damage
the coating on the glass.
• Should there occur stains on the glass, remove them
regulary, for the can burn the glass.
Figure 10.1 - Modore 185