Use and Care Manual

11
732 S Racetrack Rd, Henderson NV 89015
info@vinotemp.com
ENERGY SAVING TIPS
• The unit should be located in the coolest area of the room away from heat sources or direct sunlight.
• Ensure that the unit has proper allowances on all sides for proper ventilation. Never cover any air
vents.
• Only open the cooler door for as long as necessary. Frequent opening of the door will affect internal
temperature.
PROBLEMS WITH YOUR WINE COOLER
Most common problems can be solved easily, saving you the cost of a possible service call. Try the following
suggestions to see if you can solve the problem before contacting Vinotemp at Info@Vinotemp.com.
TR
OUBLESHOOTING
PR
OBLEM POSSIBLE CAUSE
Wi
ne Cooler does not operate
• En
sure unit is plugged into an electrical outlet.
• Check if unit is turned off.
• Check for a tripped circuit breaker or blown fuse.
Wi
ne Cooler is not cold
enough
• Ch
eck the temperature control setting.
• External environment or ambient temperature may require a higher
setting.
• Check if door does not close completely or is open too often.
• Check if door gasket does not seal properly.
Wi
ne Cooler turns on and off
frequently
• Th
e room temperature may be hotter than normal.
• Check if door does not close completely or is open too often.
• Check if door gasket does not seal properly.
• The temperature control is not set correctly.
Wi
ne Cooler light does not
work
• En
sure unit is properly plugged in.
• Check for a tripped circuit breaker or blown fuse.
• Check if the light switch is OFF.
Wi
ne Cooler makes too much
noise or vibrates
• Ch
eck to ensure the unit is level.
• The rattling noise may come from the flow of refrigerant. This is
normal.
• As each cycle ends, you may hear gurgling sounds caused by the
flow of refrigerant in the unit. This is normal.
• Contraction and expansion of the inside walls may cause popping
and crackling noises.
Wi
ne Cooler door will not
close properly
• Check to ensure the unit is level.
• The door was reversed and was not properly installed.
• The gasket is dirty.
• The shelves are out of position.










