User Manual

6
5
Ice maker mounting screws fixed
8
Fixed ice maker
□ Insert two ice maker mounting screws into the holes in
the freezer wall. Turn each screw clockwise 5 times.
6
Remove the internal cover located on
the inner ceiling
□ Use needle nose pliers to remove the internal cover located
on the inner ceiling of the freezer by first pulling down one
side of the cover, then pulling down the other side. Save the
terminal cover for future use in case the ice maker is
removed.
□ Mount the ice maker onto the two ice maker mounting
screws you installed in step 5. Make sure that the water
inlet tube is sitting inside the fill cup and the ice maker is
level, then tighten the screws.
7
Plug the wiring harness connector
into the terminal
□ With the ice maker in one hand, plug the wiring harness
connector into the terminal located at the top of the freezer
panel. Make sure that the connection is tight. Make sure
that the wiring harness is still in the hook on the back of
ice maker.
Installation Instructions - ( Top mount freezer )