Element Enduro Utility Bed Instructions

UTILITY BED: BAG 1
UTILITY BED: BAG 1
UTILITY BED: BAG 1
GATE 01
GATE 02
GATE 03
1
x4
x1
x4
42120
Sendero Body,
Bed Mount
*Not Included
42131
Utility Bed,
Cage, Right
25203
3x12mm,
FHCS
*Not Included
Utility Bed,
Cage, Right
x2
x2
x2
x1
x4
89202
3x12mm
BHCS
25202
3x10mm
FHCS
89209
3x18mm
FHCS
42131
Utility Bed,
Mounting Plate
89202
3x12mm
BHCS
x1
x1
x1
x1
x4
42131
Utility Bed,
Cage, Left
42131
Utility Bed,
Cage, Bottom
42131
Utility Bed,
Cage, Hoop
42131
Utility Bed,
Floor
4673
2.5x4mm
BHCS
PAINTING:
Your Utility Bed Floor requires painting.
You will need to prep the fl oor before you can paint it.
Wash the INSIDE thoroughly with warm water and liquid detergent (do not use any
detergents with scents or added hand lotion ingredients!). Dry the fl oor using a clean,
soft, lint-free cloth. You can use high quality masking tape, apply to the inside of the
fl oor, to create a design. Spray (use either rattle can or airbrush) the paint on the
inside of the fl oor (preferably dark colors fi rst, lighter colors last). NOTE: ONLY
use paint that is recommended for (polycarbonate) plastics. If you do not, you can
destroy the fl oor! After the paint has completely dried (usually after 24 hours), cut
the fl oor along the trim lines.
NOTE: Install bed
mounts and 3x12mm
FHCS inside the body
NOTE: There is extra hardware included
for different body mounting needs.
#89202 - 3x12mm BHCS, x4
#252015 - M3 Locknut, x4