Owner Manual

20
WARNING:
DO NOT REMOVE BURNER OR PERFORM CLEANING WHILE
GRILL IS STILL HOT
Orifice Cleaning:
Shine a flashlight to ensure there is no blockage. Use a
needle to clear any debris. Be extremely careful not to
enlarge the hole or break off the needle.
NOTE:
Installation after cleaning:
After the cleaning, properly locate and re-attach the burner.
Adjust the igniter tip located near the burner edge so that
it is approximately 2-4mm away from the burner surface.
See FIG.10.
Residue Tray Cleaning:
Remove the Cotter Pin attached to the screw shaft and unscrew
counter-clockwise to remove tray from the grill. FIG.13. Clean
residue tray after each use and reinstall.
FIG.11.
FIG.13.
FIG.12.
FIG.13.