User Manual

11. SETTINGS MENU

INP FROM selects the source Model:Samples receives MIDI data from.

• OFF makes Model:Samples disregard any incoming MIDI data.

• MID makes Model:Samples listen only to MIDI data sent to the MIDI IN port.

• USB makes Model:Samples listen only to MIDI data sent to the USB port.

• M+U makes Model:Samples listen to MIDI data sent to both the MIDI IN and USB ports. This setting

will slow the data transfer over USB down to the max speed for data transfer over MIDI.

OUT TO selects the destination to which Model:Samples will send MIDI data.

• OFF stops Model:Samples from sending out any MIDI data.

• MID makes Model:Samples send MIDI data to the MIDI OUT port only.

• USB makes Model:Samples send MIDI data to the USB port only.

• M+U makes Model:Samples send MIDI data to both the MIDI OUT and USB ports. This setting will

slow the data transfer over USB down to the max speed for data transfer over MIDI.

OUT POL sets the polarity of the MIDI OUT port to accommodate for the two dierent standards of 3.5

mm (Tip/Ring/Sleeve) to female 5 pin DIN cable wiring. The MIDI IN port is conﬁgured automatically.

OUT/THRU sets if the MIDI OUT/THRU port should function as an OUT or THRU port.

11.3.5 FILTER

Here you ﬁnd the MIDI ﬁlter related settings. Use LEVEL/DATA to browse and change the settings.

RCV NOTE will when active, make it possible to play Model:Samples using an external MIDI keyboard

or controller.

RCV CC will when active make it possible to control Model:Samples parameters from an external MIDI

device sending CC/NRPN data.

ENCS controls whether the TRACK PARAMETER, FX PARAMETER and LEVEL/DATA knobs sends

MIDI data or not.

• INT, the knobs only aect the Model:Samples and does not send any MIDI data.

• I+E, the knobs aect the Model:Samples and also send MIDI data to external devices.

If ENCS is set to INT, the encoders will not send MIDI to external devices even if the

track is set to send MIDI out. For more information, please see “8.4.2 MOUT” on page

23.

11.4 AUDIO

In this menu, you specify audio-related settings for the Model:Samples.