User Manual

9. TRACK RELATED PARAMETERS

Here follows a description of all of the parameters that are available to change the character and behavior

of the track’s samples.

9.1 PARAMETER EDITING

The TRACK PARAMETER knobs are used to change the values of the track parameters.

9.1.1 PARAMETER VALUE JUMP

Pressing [FUNC] while editing speciﬁc parameters makes the parameter values jump to appropriate

positions. For example, sample PITCH jumps whole octaves.

9.1.2 PARAMETER REVERT FUNCTION

If you have changed a parameter setting, you can press [BACK]

to revert that change to the parame-

ters previous setting. This function has a time-out function, meaning that, after you adjusted the param-

eter, you have roughly three seconds to perform the revert operation before the change is permanent.

Changes made by setting parameter locks are revertable as long as you keep the [TRIG] key pressed.

9.1.3 CONTROL ALL

If you press and hold [TRACK] and use the TRACK PARAMETER knobs to change a parameter setting,

this change aects this parameter in all the tracks in the pattern. You can also use the Parameter Revert

function on Control All operations.

The Control All operation is also available for the track LEVEL/PAN and also for the LOOP

and REVERSE settings.

9.2 TRACK PARAMETERS

The track parameters may be parameter locked to other settings on any step of the pattern by (in GRID

RECORDING mode) ﬁrst pressing and holding a [TRIG] key, and then changing the parameters’ settings

with the TRACK PARAMETER knobs. For more information, please see “8.12.1 PARAMETER LOCKS” on

page 26.

9.2.1 PITCH

Sample Pitch sets the tuning of the sample. This parameter is bipolar, and a value of 0 leaves the pitch

unchanged. (-24–+24, equivalent to four octaves.)

9.2.2 DECAY

Amp Decay sets the length of the decay phase of the amp envelope. (0–126, INF)

9.2.3 SAMPLE START

Sample Start sets the start position for playback of the sample. (0–120)

9.2.4 SAMPLE LENGTH

Sample Length sets the length of the playback of the sample. The Sample Length is deﬁned from the

Sample Start position, so if you change the Sample Start value, you also change the Sample Length

position. (0–120)

The SAMPLE START and SAMPLE LENGTH parameters with LOOP set to ON.

Sample

Start

Sample Length

9.2.5 CUTOFF

Filter Cuto sets the cuto frequency of the low-pass/high-pass ﬁlter. Negative parameter values make

the ﬁlter function as a low-pass ﬁlter. Positive parameter values make the ﬁlter function as a high-pass

ﬁlter. (-64–+63)