User Manual

8. THE SEQUENCER

8.12.4 SWING ALL

Adjust the shared swing setting of the tracks in the pattern, to employ a propulsive, rhythmic groove.

Press [FUNC] + [WAVE] to open the SWING ALL menu. Use the LEVEL/DATA knob to and change the

setting ratio. (OFF, 50–80%.) The default setting is OFF.

When SWING ALL is set to any value except OFF, the track parameter knob SWING controls the SWING

ALL value.

If SWING ALL is set to OFF, the tracks SWING parameters previous values are recalled.

For more information, please see “9.2.11 SWING” on page 32.

8.12.5 COPY, PASTE, AND CLEAR OPERATIONS

Patterns, tracks, track pages, and trigs can be copied, pasted and cleared.

The active pattern can be copied to another location in the same bank or in another bank. You must

deactivate GRID RECORDING mode to perform a pattern copy operation. Press [FUNC] + [RECORD] to

copy the pattern. Select another pattern, and then press [FUNC] + [STOP] to paste the copied pattern

to this location. Please note that you can only paste to the currently active pattern. Press [FUNC] +

[PLAY] to clear a pattern. This clear function will only clear the patterns sequencer data. For more infor-

mation about totally clearing a pattern, please see “11.1.4 CLEAR” on page 36.

You can also press and hold [PATTERN] + [TRIG 1–16] + [PLAY] to clear all pattern data.

Individual sequencer tracks can be copied, pasted and cleared in the same way as patterns but GRID

RECORDING mode must be active.

Trigs, complete with all parameter lock settings, can be copied, pasted and cleared as well. GRID RE-

CORDING mode needs to be active to access this functionality. Press and hold a trig and press [RE-

CORD] to perform the copy operation. Paste by holding another [TRIG] key and pressing [STOP]. It is

also possible to copy more than one trig. Hold several trigs and press [RECORD]. The trig ﬁrst pressed

acts as the starting point. When pasting, the other copied trigs are placed in relation to the ﬁrst trig.

Paste the copied sequence of trigs by holding another [TRIG] key and pressing [STOP]. Clear trig locks

by holding one or more trigs and press [PLAY].

You can undo any copy, paste, and clear operation by repeating the key presses.

• It is possible to copy, clear and paste one or several patterns without leaving the active

pattern. To copy, press and hold [PATTERN] + [TRIG] key to select the pattern you wish

to copy. Then press [RECORD]. Let go of the [TRIG] key and then press and hold the

[TRIG] key(s) to where you want to paste the pattern. Finally, press and hold [STOP]

until the countdown ﬁnishes to paste the pattern(s). To clear, press and hold [PATTERN]

+ [TRIG] key(s) to select the pattern(s) you wish to clear. Then press and hold [PLAY] to

clear the pattern(s).

8.12.6 TEMPORARY SAVE AND RELOAD PATTERN COMMANDS

Patterns can instantly be saved to a temporary memory space and then reloaded again from this space.

• To perform a temporary save of the active pattern, press [FUNC] + [SETTINGS]. This function is use-

ful to create a restore point when you are live tweaking, but without permanently save your changes.

• To perform a temporary reload of the active pattern, press [FUNC] + [PATTERN]. It will reload the

pattern from when you last used the temporary save command. If you have not done any temporary

save, then the pattern reloads from the permanently saved state.