User Manual
Table Of Contents
- INTRODUCTION
- THE BACKGROUND OF THE ANALOG FOUR
- PANEL LAYOUT AND CONNECTORS
- ANALOG FOUR SIGNAL PATH
- OVERVIEW OF THE ANALOG FOUR STRUCTURE
- THE USER INTERFACE
- QUICK START
- PROJECTS
- KITS AND SOUNDS
- THE SEQUENCER
- CHAINS AND SONGS
- GLOBAL MENU
- EARLY STARTUP MENU
- MORE ON OSCILLATORS, FILTERS AND ENVELOPES
- SETUP EXAMPLES
- TECHNICAL INFORMATION
- CREDITS AND CONTACT INFORMATION
- Appendix A: SYNTH TRACK PARAMETERS
- Appendix B: FX TRACK PARAMETERS
- Appendix C: CV TRACK PARAMETERS
- Appendix D: MIDI
- Appendix E: ANALOG FOUR ARCHITECTURE
- INDEX
C-2 Appendix C: CV TRACK PARAMETERS
CV (PITCH HZ/V)
TUN (Coarse Tune) sets the coarse tuning of the CV in semi-
tones.
FIN (Fine Tune) sets the fine tuning of the CV.
BND (Bend Depth) controls the bend depth. The higher the set-
ting, the more the pitch of a trigged note will be offset.
SLI (Note Slide time) sets the CV control of the slide time of note
slides.
SRC (Source Track) selects the track whose notes should be
used for sending CV signals. The CV track, FX track and synth
tracks 1-4 can be used as source.
.
CV (VALUE LIN)
VAL (Value) sets the voltage level of the CV. Applicable when the
chosen CV type is VALUE LIN.