User Manual
Table Of Contents
- INTRODUCTION
- THE BACKGROUND OF THE ANALOG FOUR
- PANEL LAYOUT AND CONNECTORS
- ANALOG FOUR SIGNAL PATH
- OVERVIEW OF THE ANALOG FOUR STRUCTURE
- THE USER INTERFACE
- QUICK START
- PROJECTS
- KITS AND SOUNDS
- THE SEQUENCER
- CHAINS AND SONGS
- GLOBAL MENU
- EARLY STARTUP MENU
- MORE ON OSCILLATORS, FILTERS AND ENVELOPES
- SETUP EXAMPLES
- TECHNICAL INFORMATION
- CREDITS AND CONTACT INFORMATION
- Appendix A: SYNTH TRACK PARAMETERS
- Appendix B: FX TRACK PARAMETERS
- Appendix C: CV TRACK PARAMETERS
- Appendix D: MIDI
- Appendix E: ANALOG FOUR ARCHITECTURE
- INDEX
SETUP EXAMPLES
69
6. Select track 1. Set WAV on the OSC1 page to IN L. For oscillator 2, choose one of the internal Analog Four
waveforms.
7. Note trigs placed on track 1 will now control both the internal and the external oscillators.
• Use parameter locks to alternate the waveform of oscillator 1 between external/internal selections.
• This example can use more than one external oscillator. If two separate external oscillators are
connected to the Analog Four external inputs, both oscillators can be used on for example track 1.
Track 2-4 could then use only internal oscillators.