User Manual

12 GLOBAL SETTINGS MENU
64
The column to the left selects what will be received. Select the column using the [LEFT] arrow key. Use
the [UP]/[DOWN] keys or the TRACK LEVEL knob to navigate in the column. The SysEx data receive
alternatives located in the column to the right will change depending on the selection made in the left
column. Press the [RIGHT] arrow key to access this column. Use the [UP]/[DOWN] keys or the TRACK
LEVEL knob to select what will be received. Press [YES] to initiate the SysEx receive procedure. The
Analog Four MKII will start listening to incoming data. Press [NO] to stop listening.
ANYTHING will listen to and receive any viable SysEx data sent.
KIT
ACTIVE KIT will when receiving kit SysEx data replace currently active kit with the received kit.
KIT 01-128 will store a received kit to the selected kit slot. An asterisk at the end of the kit name
indicates the kit is not linked to any pattern.
SOUND POOL will store a received Sound to the selected slot of the Sound Pool of the active project.
+DRIVE SOUND will store a received Sound to the selected slot of the +Drive Sound library. The op-
tion ANYWHERE will place the Sound in the first free slot available. To the right of the bank indication,
the amount of free slots can be seen.
PATTERN will store a received pattern to the selected pattern slot. To the right of the pattern slot, the
name of the kit linked to the pattern is visible. An asterisk indicates the pattern is not linked to a kit.
SONG will store a received song to the selected song slot.
GLOBAL will store a received global to the selected global slot.
Initiate the SysEx send from the sending device after the Analog Four MKII has started
listening to incoming data.
When receiving to a specific list position, any subsequent data will be received on the next
position, or positions, in the list.
The Analog Four MKII can receive SysEx data at any time, regardless of the currently ac-
tive menu. The data will be loaded into the position specified when it was saved, or the first
free slot if unspecified.
12.11 SYSTEM
Accesses the menus USB CONFIG, OS UPGRADE, FORMAT +DRIVE and CALIBRATION described below.
12.11.1 USB CONFIG
To use the Analog Four MKII as an Overbridge device, you must set it to Overbridge mode. Do so by se-
lecting the OVERBRIDGE MODE menu item and ticking the box by pressing [YES]. For more information,
please see “6.6 OVERBRIDGE” on page 19.
Should you, for some reason, wish to disable the Overbridge integration functionality, select the item
called USB-MIDI ONLY and press [YES].