User Manual
12 GLOBAL SETTINGS MENU
62
Activate/deactivate routing of any the four voices to the main output and the FX track. Navigate using the
[ARROW] keys. Tick or untick box with the [YES] key.
Alternatively, instantly activate or deactivate voice to main or voice to FX using the [TRIG] keys 1-4 and 9-12,
respectively. Red LEDs above these sets of keys will show if the voice is active (full-bright) or inactive (half-
bright).
Note that voice routing can be set and stored for each individual kit and that these settings override the
GLOBAL voice routing unless they are set not to. For more information, please see “9.2 KIT MENU” on page
23.
12.8 CONTROL INPUT 1
This menu item accesses the settings for the Control In 1 input. You can use this input to plug in dierent
modulation sources. The modulation is set in the CONTROL IN 1 MOD menu. For more information, please
see “9.2.8 CONTROL 1 IN MOD” on page 24.
MODE
Sets the port mode to adjust to dierent kinds of input signals. There are three modes: CV (Control Volt-
age), EXPR (Expression Pedal), and OFF.
CV ZERO LEVEL (Available when mode is set to CV.)
Sets the Volt level at which CV modulation amount is zero. A control input level equal to this setting cor-
responds to zero modulation. (. V–+5.50 V).
CV MAX LEVEL (Available when mode is set to CV.)
Sets the Volt level at which CV modulation amount is max. A control input level equal to this setting cor-
responds to full modulation. (. V–+5.50 V).
EXPRESSION LEARN (Available when mode is set to EXPR.)
Sets the highest and lowest limit of the control input level. When in this setting, connect the Expression pedal
to CONTROL IN A/B. Press YES and then move the expression pedal first to max and then to min
position. Press YES to save settings.
REVERSE DIRECTION (Available when mode is set to EXPR.)
Reverses the direction of how the Expression pedal sends control input signals.
12.9 CONTROL INPUT 2
The available settings are the same as for CONTROL IN 1.
12.10 SYSEX DUMP
In the SYSEX DUMP menu, kits, Sounds, patterns, songs and global slots can be sent and received. Select
a menu option using [UP]/[DOWN] or the TRACK LEVEL knob. Press [YES] to open the highlighted menu
selection.