User Manual

9. KITS AND SOUNDS

9.11.1 OSCILLATOR DRIFT

Will when activated introduce a very subtle pitch drift to the oscillators, which can increase their per-

ceived “warmth.”

9.11.2 F1 RESONANCE BOOST

Increases the amount of resonance from the ﬁrst ﬁlter. it aects the resonance and gain of both upper

and lower frequencies.

9.11.3 VELOCITY TO VOL

Selects how MIDI velocity aects volume when playing the Sound from a MIDI keyboard.

OFF means velocity will not aect the volume of the Sound.

LOG will apply a logarithmic velocity curve. The volume dierence will be greater between softer key-

board presses than between harder.

LIN will apply a linear velocity curve. The volume dierence between keyboard presses will correspond

linearly to the force applied.

EXP will apply an exponential velocity curve. The volume dierence will be greater between harder

keyboard presses than between softer.

9.11.4 LEGATO MODE

Can be turned either o or on. When the mode is activated, envelopes will not be retrigged for overlap-

ping notes played manually on the [KEYBOARD] keys or incoming MIDI notes trigging Sounds. Note that

notes on the sequencer are not aected.

9.11.5 PORTAMENTO

Will when active make the pitch slide between notes. The settings only aect notes played manually

on the [KEYBOARD] keys or incoming MIDI notes trigging Sounds. Notes on the sequencer will not be

aected. For more information, please see “10.12.7 NOTE SLIDE” on page 48.

OFF turns portamento o. No played notes will be aected.

ON turns portamento on. All played notes will be aected.

LEGATO activates portamento for overlapping notes only. LEGATO MODE needs to be activated for

this setting to function.

9.11.6 VELOCITY MOD

Gives access to a menu where up to 5 PARAMETER page parameters can be assigned to the velocity

parameter. Both the VEL parameter of the NOTE menu and the velocity of incoming MIDI notes sent

to the Analog Four MKII from external devices will aect the assigned parameters. Open the menu by

pressing [YES]. Setting up the parameters works in the same way as setting up performance macros.

For more information, please see “9.3.1 PERFORMANCE SETUP MENU” on page 25.

9.11.7 PITCH BEND

Gives access to a menu where up to 5 PARAMETER page parameters can be assigned to the MIDI pitch

bend command. If MIDI pitch bend messages are sent to the Analog Four MKII from an external device,

these messages will aect the parameters assigned in this menu. Open the menu by pressing [YES].

Setting up the parameters works in the same way as setting up performance macros. For more informa-

tion, please see “9.3.1 PERFORMANCE SETUP MENU” on page 25.

9.11.8 MODULATION WHEEL

Gives access to a menu where up to 5 PARAMETER page parameters can be assigned to the MIDI mod

wheel command (CC #1). Open the menu by pressing [YES]. Setting up the parameters works in the

same way as setting up performance macros. For more information, please see “9.3.1 PERFORMANCE

SETUP MENU” on page 25.