User Manual

Page 27
EA Elektro-Automatik GmbH
Helmholtzstr. 31-33 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
www.elektroautomatik.de
[e-mail]
PSI 9000 3U Series
1.10.7 USB port type B (rear side)
The USB-B port on the back side of the device is provided for communication with the device
andforrmwareupdates.TheincludedUSBcablecanbeusedtoconnectthedevicetoaPC
(USB 2.0 or 3.0). The driver is delivered on the included CD and installs a virtual COM port.
Details for remote control can be found on the web site of the manufacturer or on the included
CD. A general programming introduction for the USB port is available (date: 04-14-2014)
The device can be addressed via this port either using the international standard ModBus pro-
tocol or by SCPI language. The device recognises the message protocol used automatically.
If remote control is in operation the USB port has no priority over either the interface module
(see below) or the analog interface and can, therefore, only be used alternatively to these.
However, monitoring is always available.
1.10.8 Interface module slot
This slot on the back side of the device is available for various modules of the AnyBus
CompactCom (abbr.: ABCC) type of the IF-AB interface series. The following options are
available (date: 04-14-2014):
Article number Name Description
35400100 IF-AB-CANO CANopen, 1x Sub-D 9pole male
35400101 IF-AB-RS232 RS 232, 1x Sub-D 9pole male (null modem)
35400103 IF-AB-PBUS ProbusDP-V1Slave,1xSub-D9polefemale
35400104 IF-AB-ETH1P Ethernet, 1x RJ45
35400105 IF-AB-PNET1P ProNETIO,1xRJ45
35400106 IF-AB-DNET Devicenet, 1x Wago plug 5pole
35400107 IF-AB-MBUS1P ModBus TCP, 1x RJ45
35400108 IF-AB-ETH2P Ethernet, 2x RJ45
35400109 IF-AB-MBUS2P ModBus TCP, 2x RJ45
35400110 IF-AB-PNET2P ProNETIO,2xRJ45
Themodulesareinstalledbytheuserandcanberetrottedwithoutproblem.Armwareupdateofthedevicemay
be necessary in order to recognize and support certain modules.
If remote control is in operation the interface module has no priority over either the USB port or the analog interface
and can, therefore, only be used alternately to these. However, monitoring is always available.
Switch off device before adding or removing modules!
1.10.9 Analog interface
This 15 pole Sub-D socket on the back side of the device is provided for remote control of
the device via analog signals or switching conditions.
If remote control is in operation this analog interface can only be used alternately to the
digital interface. However, monitoring is always available.
The input voltage range of the set values and the output voltage range of the monitor val-
ues, as well as reference voltage level can be switched in the settings menu of the device
between 0-5 V and 0-10 V, in each case for 0-100%.