User Manual

9
Instruction manual
PS 2000 B Single Series
EN
Date: 06-03-2011
Safety instructions
• Only operate the device at a mains voltage as stipulated
on the type plate!
• Never insert mechanical parts, especially from metal,
through the air ventilation slots!
• Avoid any use of liquids of any kind in the proximity of
the device! They might get into it.
• Do not connect voltage sources to the device which are
able to generate voltages higher than the nominal voltage
of the device!
• Do not connect voltage source with reversed polarity to
the output!
• After the output or even the device has been switched
there can still be dangerous voltage on the output! At
least for a certain time.
• Attention! The enclosure can heat up during operation
and may be hot!
General
About
Elektro-Automatik GmbH & Co. KG
Helmholtzstrasse 31-33
41747 Viersen
Germany
Phone: +49 2162 / 37850
Fax: +49 2162 / 16230
Web: www.elektroautomatik.de
Mail: [e-mail]
© Elektro-Automatik
Reprint, duplication or partly, wrong use of this user in-
struction manual are prohibited and might be followed by
legal consequences.
Page
1. Introduction............................................................ 10
2. Technical specications ......................................... 10
3. Installation ............................................................. 10
3.1 Mains connection ............................................. 10
3.2 Connecting loads ............................................. 10
4. Views ......................................................................11
4.1 Controls & sockets ............................................11
5. Handling ................................................................ 12
5.1 The display ................................................ 12
5.1.1 Status tokens .............................................. 12
5.1.2 Error indication ............................................ 12
5.2 Pushbuttons ..................................................... 12
5.2.1 Pushbutton Preset ............................... 12
5.2.2 Pushbutton On/Off ............................... 12
5.3 Further control elements .................................. 12
5.4 Adjusting set values ........................................ 13
5.5 Control panel lock (LOCK) ............................... 13
6. Behaviour of the device ......................................... 13
6.1 Switching on by power switch .......................... 13
6.2 Overvoltage ...................................................... 13
6.3 Overtemperature .............................................. 14
6.4 Overcurrent ...................................................... 14
7. Trouble-shooting ................................................... 14
7.1 Hardware problems .......................................... 14
8. Other applications ................................................. 14
8.1 Series connection ............................................. 14
8.2 Parallel connection ........................................... 14
8.3 Remote control ................................................. 14
8.4 Firmware udpates ............................................ 14