User Manual

Page 34
ELR 9000 Series
www.elektroautomatik.de
ea1974@elektroautomatik.de
EA Elektro-Automatik GmbH
Helmholtzstr. 31-33 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
2.3.12 Initial commission
For the rst start-up after purchasing and installing the device, the following procedures have to be executed:
• Conrm that the connection cables to be used are of a satisfactory cross section
• Check that the default settings for set values, safety and monitoring functions and communication are suitable
for your application and change them where necessary, as described in the manual
• In case of remote control via PC, read the additional documentation for interfaces and software
• In case of remote control via the analog interface, read the section in this manual concerning analog interfaces
and, where needed, other appropriate documentation especially concerning the use of such interfaces
2.3.13 Commission after a rmware update or a long period of non use
In case of a rmware update, return of the equipment following repair or a location or conguration change, similar
measures should be taken to those of initial start up. Refer to „2.3.12. Initial commission“.
Only after successful checking of the device as listed may it be operated as usual.