User Manual
Page 39
EA Elektro-Automatik GmbH
Helmholtzstr. 31-33 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
www.elektroautomatik.de
ea1974@elektroautomatik.de
ELR 9000 Series
MENU General Settings
User Events
Profiles
Overview
About HW, SW...
Page 1
Page 2
Allow remote control: Yes | No
Input after power ON: OFF | Restore
Page 3 Analog interface range: 0...5V | 0...10V
Voltage controller setting: Slow | Fast
Page 5 Calibrate device: Start
Page 6 Reset device to defaults: Start
Page 7 Enable Master-Slave: OFF | ON
Event U
Event I
Event P
UVD = {0V...Unom}
Aktion = {NO | SIGNAL | WARNING |ALARM}
OVD = {0V...Unom}
Aktion = {NO | SIGNAL | WARNING |ALARM}
UCD = {0A...Inom}
Aktion = {NO | SIGNAL | WARNING |ALARM}
OCD = {0A...Inom}
Aktion = {NO | SIGNAL | WARNING |ALARM}
OPD = {0W...Pnom}
Aktion = {NO | SIGNAL | WARNING |ALARM}
Default Profile
User Profile 1
User Profile 2
User Profile 3
User Profile 4
User Profile 5
Page 8 Link mode: MASTER | SLAVE
Device address: 0, 1...16
Page 9 Repeat master init: Init. Master
DC- connection: Parallel | Serial
Page 4 Controls mode: U/I | P/I | R/I
Parameters in curly brackets describe the selectable range, underlined parameters show the default value after delivery or reset.