Operation Manual

2.4
PKF 255 V8
Symbols shown on the machine
A
Danger!
Disregard of the following warnings can lead
to severe personal injury or material damage.
Read instructions.
Do not reach into the revolving saw blade.
f
Wear hearing protection.
Use push stick if distance
between saw blade and rip fence
is £ 120 mm.
Cut round stock only with a suita-
ble holding device.
Use table extension, if otherwise
workpiece would fall off the table
after cutting.
Max. saw blade Ø 250 mm
Saw blade arbor bore Ø 30 mm
Max. blade speed 4000 min
-1
Max. depth of cut 80 mm
Safety devices
Riving knife
The riving knife prevents the workpiece from being
caught by the rising teeth of the saw blade and
being thrown against the operator.
Always have riving knife installed during operation.
Blade guard
The blade guard protects against accidental contact
with the blade and keeps chips from flying about.
Always have blade guard installed during operation.
Push stick
The push stick serves as an extension of the right
hand and protects against accidental contact with
the saw blade.
Always use push stick if distance
rip fence saw blade is £ 120 mm.
In order for the push stick to be always at hand, it
can be stored in a sheath in the machine's housing
(arrow).
Operating controls
On/off switch with motor protection
· To start main saw blade
= set rotary switch to ON.
· To start scribing blade= push green button.
· To stop everything
= set rotary switch to OFF or hit red button.
3
A motor protection switch is built into the
switch enclosure, to switch the motor off in
the event of an overload.
An undervoltage relay trips in the event of a
voltage failure, to prevent a restarting of the
saw when the power is restored.
To start the saw again after a power failure
the on/off switch has to be set to ON.
90