Operation Manual

2.11
PKF 255 V8
4. Set depth of cut. The blade guard should be
approx. 10 mm above the workpiece.
5. Set saw blade tilt and lock in position.
6. Start main saw blade (rotary switch to ON).
7. Place workpiece against fence extrusion and
hold it firmly.
3
If you want to cut several workpieces to the
same length, use the flip stop. The work-
pieces are placed with their left edge against
the flip stop.
8. Push travelling sizing table forward to cut work-
piece in a single pass.
9. Switch machine off if no further cutting is to be
done immediately afterwards.
Trimming with the hold-down plate
The hold-down plate firmly holds long stock on the
travelling sizing table for cutting. This way a clean
and straight cut is possible without mitre or parallel
fence. This is especially useful for trimming cuts.
A
Danger!
Do not cut stock of less than 120 mm in width
without mitre or parallel fence! Otherwise
there is no sufficient distance between the
saw blade and the hand.
1. Slide hold-down plate from the rear into the
groove of the travelling sizing table and tighten.
2. Set depth of cut. The blade guard should be set
to approx. 10 mm above the workpiece.
3. Set saw blade tilt and lock in position.
4. Unlock travelling sizing table travel lock and pull
travelling sizing table towards you.
5. Place workpiece on travelling sizing table and
push it against the hold-down plate.
6. Start main saw blade (rotary switch to ON).
7. Push travelling sizing table forward to cut work-
piece in a single pass.
8. Switch machine off if no further cutting is to be
done immediately afterwards.
Dimensioning with the scribing blade
With the scribing blade veneered or faced sheets
are dimensioned without edge chipping.
The scribing blade must be exactly aligned with the
main blade.
For more information on scribing blade setting see
„Care and maintenance“
1. Set depth of cut of the main blade. The blade
guard should be set to approx. 10 mm above the
workpiece.
2. Set blade tilt and lock in position.
3. Start main saw blade (rotary switch to ON).
4. Start scribing blade (press green button).
5. Cut workpiece in a single pass.
6. Switch machine off if no further cutting is to be
done immediately afterwards.
Care and maintenance
A
Danger!
Prior to all servicing:
- Switch machine OFF.
- Unplug power cable.
- Wait until the saw has come to a complete
stop.
· Check that all safety devices are operational
again after each service.
· Replace defective parts, especially of safety
devices, only with genuine replacement parts.
Parts not tested and approved by the equipment
maker can cause unforeseen damage.
· Repair and maintenance work other than
described in this section shall only be carried out
by qualified specialists.