Owner Manual

Vessel Sink Installation Instructions
*
drain assembly, mounting ring and the faucet needs to be purchased separately!
*
all vessel sinks do not have an overflow and require pop-up or twist drain assembly!
*
follow the steps below to install your new vessel
STEP 1
Cut out 1 3/4” hole on the counter-top for the drain.!
STEP 2
Carefully, position the sink in the cutout opening on the mounting
ring. NOTE: Mounting ring needs to be purchased separately
with your drain assembly and the faucet.!
STEP 3
Tighten the drain assembly lock nut by hand until it stops turning,
make sure all the washers are used and in their proper places.
Washers should be included with your drain assembly. Carefully
tighten the nut with a wrench for final tightening. !
CAUTION! Do not overtighten drain assembly as this
may cause the vessel to chip or crack.
CARE INSTRUCTIONS
*
never use strong abrasive cleaner!
*
use a soft, dampened cloth!
*
never use brush or scouring pads they will scratch the glass!
*
always rinse and wipe the sink to prevent soap buildup!
T