Instructions / Assembly

Notes:
Avoid placing objects in front of the motion detector
Avoid installation near air conditioners/central heaters/high voltage systems
Avoid placing the motion detector head towards high movement areas
Clean the solar panel with a moist soft cloth at least once a year
Clean accumulated snow as soon as possible during the snowing season
Do not expose the light to fire/intense heat or immerse in water
Never look directly into the light or shine it into another person’s eyes
Contact Info: [phone], [e-mail], www.eleding.com
EE800W-SFLH-F series 04242017
page 2
Solar-Power Building/Bus Stop Advertising/Security/Safety Wall Pack LED Illuminator
eLEDing EE805W1F & EE810W2F Quick Set-up Reference
Components & Light Installation (Fig 1)
For wall-mounted application, drill three holes A, B and C on desired locations, secure the light body with provided screws (Fig 2).
For wood surfaces: drill the holes on pre-marked locations and install the mounting bracket.
For surfaces of concrete, brick or stucco: use a masonry bit (with appropriate size & length) to drill clearance holes.
Solar Panel Installation
An ideal installation area should be a flat and stable mounting surface that can ensure the maximum exposure to direct sunlight. An
average of 4-hour direct sunlight per day is necessary for dusk-to-dawn performance. The light will automatically turn off when it
detects low voltage from the battery. This might happens after 3-4 cloudy days. For northern hemisphere installation, a south-facing
installation is recommended and vice versa. East/west-facing installations with good sunlight exposure also works.
Functionality Test & Activation (Fig.3)
If your testing is lunched during daytime, make sure the solar panel is fully covered by a piece of cardboard. Press the red color ON/
OFF button to activate the light. If the light doesn’t turn on, recharge the battery for 1-2 days on sunny days. To shut down the light,
during the time when light turns on, momentary press the ON/OFF button for 1-2 seconds, the light will turn off completely.
True Dusk to Dawn Illuminating Profile (Fig.3):
During daylight hours, the sun will charge the battery through solar panel. Features with IPM, when the built-in photocell senses the
ambient light level is lower than 10 LUX (darkness environment), the light will automatically turn on with maximum brightness for the
first 5 hours. After 5 hours, the light will switch to energy-saving mode by dimming down to 25% of maximum brightness for the rest
of the night. When dawn comes, the light extinguishes when ambient light level start to increase. This light does not feature with any
motion sensing technology.
Fig. 2
Fig. 3
Specification
Fig. 1