User guide

IMAGESTAR HD USER GUIDE Appendix A: Control Protocol
I460GB issue 4 Page 73
Preparing HyperTerminal
 Start HyperTerminal – Start | All Programs | Accessories | Communications |
HyperTerminal.
The following dialog will appear:
 Type in a Name for the new connection (e.g. ImageStar Setup).
 Click OK – the following dialog will appear:
 In the Connect using list box choose the TCP/IP (Winsock) option.
 Type in the IP address of the ImageStar HD in the Host address box.
 Type the number 37532 in the Port number box.
 Click OK.
HyperTerminal will now try to connect to the ImageStar HD. If the connection is successful
the status bar will show ‘Connected’ on the left hand side: