User guide

Section 3: Configuration IMAGESTAR HD USER GUIDE
Page 62 I460GB issue 4
Restoring Default Settings
An ImageStar HD can be returned to its default factory setup by using the Set Defaults function. All
current settings will be lost.
The default settings are:
• Output Mode: XGA 60Hz (mode 5) no genlock
• Screen Map: 2×2 XGA with no over/underscan or offset
• Source Clip: 2×2 XGA from current graphics source
To restore the Default Settings…
 In the ImageStar HD Devices window click on the ImageStar icon to highlight it (thick red
outline):
 Click the Devices menu and choose Set Defaults.
The Commands dialog will appear, showing the SetDefaults command string:
 To send the command, click OK. Remember that all current settings will be lost.
The following message will appear:
NOTE: A reboot is only necessary when changing the Output Format to or from SXGA+.
 Click OK and, if necessary, reboot the device (see page 41).
IMPORTANT NOTE: Remember that the control connection established between ImageStar
Configuration and the ImageStar HD is not maintained following a reboot operation. Therefore,
you will need to ‘disconnect’ then ‘reconnect’ to the device to restore the connection.