User guide

IMAGESTAR HD USER GUIDE Section 3: Configuration
I460GB issue 4 Page 49
Using the Identify Function
The Identify function causes the red source LEDs on the front of the ImageStar HD to flash briefly.
In a multi-processor system this can be used to help identify which device is which.
IMPORTANT: All current wall layout and clip settings will be cleared from the ImageStar HD.
These settings will need to be reapplied following use of the Identify function.
 In the Network window, click the Local Name of the required device.
 Click the Network menu and choose Identify.
The red source LEDs on the front of the corresponding ImageStar HD will switch to input 1
(for 3 seconds) then to input 2 (for 3 seconds) and finally back to input 1.