User guide

HD Player Chapter 12: Remote Control Protocols
76 Rev. 6.0
Available Player Commands
The following table illustrates the commands that are supported by the HD Player.
Command Action
C6
Play
C5
Pause
E4
Video Off
E3
Video On
E5
Chapter Mode (FrameNo = first file to play in playlist)
E6
Frame Mode
83
Audio On
84
Audio Off
A2
Set stop point for play list. ( FrameNo = last file to play in playlist.)
To use the ES400 protocol to control the HD Player, the following steps should be performed.
 Set up a Playlist containing the files to be used in the installation.
 Send a chapter start with the FrameNo field set to the first chapter to play in the Playlist.
 Send a stop point with the FrameNo Field set to the last chapter to play in the Playlist.
 Send a Play command to play the files.
Pioneer LDP Protocol
This protocol emulates the text protocol used to control Pioneer Laser disk players. The protocol consists of short
ASCII text commands terminated with a carriage return.
The HD Player supports the following subset of the protocol.
Play - PL<CR>
This command begins playback of the Video stream.
Stop - RJ<CR>
This command stops playback of the Video stream, and sets the HD video output to black.
Still - ST<CR>
This command stops playback of the Video stream, and leaves a freeze frame on the HD video output.
Chapter Search - CH<number>SE<CR>
This command is used to select a different file for playback. <number> contains a numeric ASCII value
specifying the required entry in the Playlist.
e.g. CH12SE<CR> - select entry 12 in the Playlist.
Note that chapter search does not cause the file to start playing.
Frame Search - <number>SE<CR>