User guide

HD Player Chapter 12: Remote Control Protocols
74 Rev. 6.0
Returns a list of the files loaded into the current playlist.
Audioon <Channel>
Turn audio on for the requested channel.
Audiooff <Channel>
Mute the audio on the requested channel.
Videoon <Channel>
Turn on video for the requested channel.
Videooff <Channel>
Turn off (“Mute”) video on the required channel.
Loopon <Channel>
Enable the Auto repeat mode. This will cause the channel to loop (auto-repeat) at the end of the selected files in
the playlist.
Loopoff <Channel>
Turn off the loop flag for the requested channel.
Note: Currently, the frame number is ignored, but is a required parameter, and should be sent as 0. The frame
number is included in the protocol for future expansion.
Shutdown
Shut the HD Player system down.
Reboot
Reboot the HD Player.
The following are remote control versions of the Timecode properties in the Clip Properties dialog:
Tcgenerate <Channel> hh:mm:ss:ff
Turns the timecode generator on and sends the timecode hh:mm:ss:ff out as a jam sync.
Tcreceive <Channel>
Sets the player into timecode receive mode.
Tcplayat <Channel> hh:mm:ss:ff
Sets the timecode playat time
Tcstopat <Channel> hh:mm:ss:ff
Sets the timecode stopat time
Tcstart <Channel>
Starts the timecode running (assumes the player is in Generate mode – refer to “The Timecode configuration
dialog” section of Chapter 6: Timecode)
*****Tcreceiveloop <Channel>
xxxxxx