User guide

HD Player Chapter 6: Timecode
45 Rev. 6.0
Note: A Clip has to be cued using the transport controls or a remote control message for the timecode settings to
be activated.
Start Time
This is the timecode that will be generated when a play command is received after the clip a cued. If the Play At
(see below) option is not enabled, this will also be the point when video output begins. The HD Player will output
this timecode, as a “Jam Sync” signal, when a cue command is issued.
Play At
Select the Play At box and enter a time to set a pre-roll, i.e. a period where timecode is generated before the video
starts. This might be used for pre show setup before the video begins.
Click here