Install Instructions

Stinger CLASSIC

Key Less, Live More!™

Teamxiq.com

Checklist before Installation

❏ I have an Electric Golf Cart

❏ The maximum current through the ignition switch

does not exceed 2 Amps when the Golf Cart and all

accessories are turned on.

Checklist after Installation

❏ Your Golf Cart does not drive when Stinger is off and

throttle is engaged.

❏ All connections are secure and won’t come off due to

driving vibrations.

Installation Instructions for Club Car Precedent/Onward, E-Z-GO

TXT, or Yamaha Drive. For more detailed instructions, view the

“Stinger Electric Cart Install Guide” on the XiQ YouTube

Channel.

1. Remove the dashboard

2. Remove the ignition switch

3. Remove connectors from

switch

4. Mount the Stinger to the

dashboard

(A secure lock nut is provided, if

necessary use provided spacer)

5. Connect the Stinger

For most of the following electric carts: ClubCar Precedent and Onward, E-Z-

GO TXT, Yamaha Drive .

BLUE STINGER WIRE - BLUE IGNITION SWITCH WIRE

GREEN STINGER WIRE - GREEN IGNITION WIRE

RED STINGER WIRE - RED BATTERY METER WIRE

BLACK STINGER WIRE - BLACK (with YELLOW stripe) BATTERY METER WIRE

PAGE 1
Stinger CLASSIC Install Instructions Key Less, Live More!™ Teamxiq.com Installation Instructions for Club Car Precedent/Onward, E-Z-GO TXT, or Yamaha Drive. For more detailed instructions, view the “Stinger Electric Cart Install Guide” on the XiQ YouTube Channel. Checklist before Installation ❏ I have an Electric Golf Cart ❏ The maximum current through the ignition switch does not exceed 2 Amps when the Golf Cart and all accessories are turned on. 1. Remove the dashboard 2.
PAGE 2
Stinger User Instructions. Example Card: CAUTION: The Stinger is designed to operate cart ignitions and monitor the battery power levels (*see battery meter advisory on back). Therefore, it performs best under the specific set of conditions described in the installation process. Please install exactly as directed. DO NOT attempt to connect the Stinger in series to other accessories such as speakers, lights, voltage regulators, etc. Doing so will hinder or prevent optimum Stinger performance.
PAGE 3
FCC Compliance Annex to Installation Manual ElectroniXIQ, INC. FCC ID: 2ALIF-STR02 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Caution to the user: changes or modifications not expressly approved by ElectroniXIQ, INC.