User's Manual

September 06, 2022

CLS-4-420-TH

FCC COMPLIANCE AND ADVISORY STATEMENT

This device complies with Part 15 of the FCC rules. Operaon is subject to the following two condions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference that may cause undesired

operaon.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant

to part 15 of the FCC Rules. These limits are designed to provide reasonable protecon against harmful

interference when the equipment is operated in a commercial environment. This equipment generates,

uses, and can radiate radio frequency energy and, if not installed and used in accordance with the

instrucon manual, may cause harmful interference to radio communicaons. Operaon of this

equipment in a residenal area is likely to cause harmful interference in which case the user will be

required to correct the interference at his own expense.

Any changes or modicaons not explicitly approved by Electronics4All Inc. could cause the device to

cease to comply with FCC rules Part 15, and thus void the user's authority to operate the equipment.

FCC RF EXPOSURE STATEMENT

This equipment complies with FCC radiaon exposure limits set forth for an uncontrolled environment.

This transmier must not be co-located or operang in conjuncon with any other antenna or

transmier. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, this

equipment should be installed and operated with minimum distance 20 cm (7.6 inches) between the

antenna and your body during normal operaon. Users must follow the specic operang instrucons

for sasfying RF exposure compliance.

ISED RF EXPOSURE STATEMENT

This equipment complies with ISED RSS-102 radiaon exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated with minimum distance 20 cm (7.6

inches) between the radiator and any part of your body. This transmier must not be co-located or

operang in conjuncon with any other antenna or transmier.

Pour se conformer aux exigences de conformité ISED RSS-102 RF exposion, une distance de séparaon

d'au moins 20 cm doit être maintenue entre l'antenne de cet appareil et toutes les personnes. Lanceurs

ou ne peuvent pas coexister cee antenne ou capteurs avec d’autres.

RSS-GEN TRANSMIT ANTENNA STATEMENT

This radio transmier IC: 26661-CLS01 has been approved by Innovaon, Science and Economic

Development Canada to operate with the antenna types listed below, with the maximum permissible

gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain

indicated for any type listed are strictly prohibited for use with this device.

Le présent émeeur radio IC: 26661-CLS01 a été approuvé par Innovaon, Sciences et Développement

économique Canada pour fonconner avec les types d'antenne énumérés ci dessous et ayant un gain

admissible maximal. Les types d'antenne non inclus dans cee liste, et dont le gain est supérieur au gain

maximal indiqué pour tout type gurant sur la liste, sont strictement interdits pour l'exploitaon de

l'émeeur.