User Instructions

Condenal
February 23, 2022
CLS-4-420-TH
9
PAIRING A CLS-4-420-TH TO A GATEWAY
To test RF funconality, a compable Bluetooth device, a CLS-4-420-TH (Wireless Sensor) must be
paired to the Gateway. The CLS-4-420-TH will broadcast an encrypted BLE data packet to the Gateway
at predetermined intervals.
The rotary encoders set the broadcast interval of the CLS-4-420-TH in 20 second increments, from 01
(20 seconds) to 09, and in 200s increments, from 11 (200 seconds) to 91 (16200 seconds) Seng 92 to
99 is the same as 91. Seng 00 or 10 disables broadcasts.
Note that the CLS-4-420-TH does not need to be connected to an external power source to transmit
BLE data packets. The CLS-4-420-TH may be operated from the internal baery.
1. Place the Gateway in Pairing Mode by pressing and releasing the PB1 pushbuon on the Gateway.
The Green COM LED will turn on.
2. Press and hold the PB1 buon on the CLS-4-420-TH. The Red COM LED on the CLS-4-420-TH will
turn on for 1 second. Release the PB1 buon on the CLS-4-420-TH.
3. If pairing was successful, the Green COM LED on the CLS-4-420-TH will then turn on for 1 second,
and the Green COM LED on the Gateway will turn o. If pairing was not successful, the Green COM