Assembly Instructions

FEBRUARY 11, 2022
CLS-4-420-th
26
3
Find a Port (1), Set a speed to 115200.
Select a New Open (2).
4
Press and hold PB1 and PB2 buon
together for 6 seconds, aer 6 seconds
let go PB2 buon and hold PB1 buon
unl the line appears on tera term
terminal.
5
Line appears on tera term terminal. It says
type ‘h’ for menu opon.
6
Type ‘h’ and press Enter. It will give you
opon. In Tera Term, type the following
leers: “p, g, k” to check the cell current,
cell SOC, provision. Aer the test type ‘r’
to reset the device.
7
A X-LAB GTW-BL100 gateway is used for this
test. Follow the GTW-BL100 operang
manual for the set-up. The node IP address
to be programmed into the gateway or
provided by Electronics4all.
8
Press PB1 buon on the gateway, it will
turn ON the green COM LED.