Assembly Instructions

FEBRUARY 11, 2022
CLS-4-420-th
21
9
Ensure that the wires coming o the DC
input jack are not in contact with the main
CCA.
10
Install four (4) 4-20 x 5/16 screws using
a #1 Phillips bit and driver. Finger
ghten the screws.
11
Connect the antenna cable to P300 on
the main CCA. The connecon should
snap once seated correctly. Note that
both the connector and cable are
delicate, should be manipulated with
care.
12
The coaxial cable from the antenna
should form a gentle loop as shown in
the above image.
13
Install the lithium-ion baery in the
baery holder. ENSURE THAT BATTERY
POLARITY IS FOLLOWED. The baery
should snap down into place in the
holder.
14
Install the Daughter Connector CCA into
J100 and J101 on the main CCA. Ensure
the connecon pins are aligned before
pressing the board down into place.