Assembly Instructions

FEBRUARY 11, 2022
CLS-4-420-th
20
3
Install the washer and nut removed in
step 1 back on to the DC input connector.
4
Tighten the DC input nut to 15 in-lbs.
using a 10 mm socket and a torque driver.
5
Install the membrane tail into the
membrane connector on the main CCA.
6
Carefully guide the main CCA into
posion. The membrane tail should loop
as shown in the image, and the antenna
connector tail should be located above
the CCA.
7
Ensure that the pins on J500 on the main
CCA aligns correctly with the header on
the rotary encoder CCA. Once aligned,
push the board forward to seat the
connecon.
8
Let the main CCA rest on the housing. The
four (4) holes on the main CCA should be
aligned with the four (4) mounng posts
on the housing.