Assembly Instructions

FEBRUARY 11, 2022
CLS-4-420-th
12
3
Start the Texas Instruments UniFlash
soware. The program should automacally
detect and display the JTAG programmer.
Select the start buon.
4
Under the Program tab, select the Browse
buon to the right of Flash Image(s).
Navigate and select the rmware image to
load into the CCA.
5
When the le is selected, the Load Image
buon will be enabled. Select the Load Image
buon.
6
Once the rmware has been loaded, a
SUCCESS message will appear in the console
window.
7
In the Sengs & Ulies tab, scroll down to
Primary BLE Address and select Read. The 12
characters BLE MAC address will be displayed
in the console window.
8
Print a label with both the Main CCA serial
number retrieved from the master
spreadsheet and the 12-character BLE
address using P-touch P-700 label maker and
P-touch Editor soware.