Assembly Instructions

FEBRUARY 11, 2022
CLS-4-420-th
9
7
Install two (2) M2.2*4mm Screws using
a T6 torx Screwdriver. Fingers ghten
the screws.
8
Ensure the rotary encoder circuit board
is seated parallel to the enclosure.
9
Install the antenna connector in the
housing opening. The at edge of the
connector should face away from the
membrane.
10
Loosely install the lock washer and nut
supplied with the connector. Tighten the
connector nut to 15 in-lbs using torque
screwdriver.
11
Rest the DIN mount in the rear housing
cavity. Install two (2) #6 lock washer into
the outer screw holes. Install two (2) 6-
32*3/8” screws using a #2 Phillips bit.
Torque screws to 10 in-lbs.
12
Ensure the DIN mount is aligned correctly:
The spring clip should be posioned
opposite to the top of the housing.