User Manual

August 24, 2021
AT-105/TP-100-TH
10
5
Snap the new baery into the baery
holder. The sensor will reset, indicated by
an LED paern on the two LEDs.
6
Reinstall the push buon top.
7
Replace the enclosure lid and re-install
the two (2) 4-40 Phillips machine screws.
8
Push and release the buon to test
buon operaon. The red LED should
turn on for 1 second.
MOUNTING
Two (2) screw mounts are provided on the
sides of the enclosure to secure the sensor.
The openings support 8-32 screws.
FIGURE 6 MOUNTING PROVISIONS